Shanghai Sunland Industrial Co., Ltd is the top manufacturer of Personal Protect Equipment in China, with 20 years’experience. We are the Chinese government appointed manufacturer for government power,personal protection equipment , medical instruments,construction industry, etc. All the products get the CE, ANSI and related Industry Certificates. All our safety helmets use the top-quality raw material without any recycling material.
bicycle helmets for men
We provide exclusive customization of the products logo, using advanced printing technology and technology, not suitable for fading, solid and firm, scratch-proof and anti-smashing, and suitable for various scenes such as construction, mining, warehouse, inspection, etc. Our goal is to satisfy your needs. Demand, do your best.
Professional team work and production line which can make nice quality in short time.
The professional team provides 24 * 7 after-sales service for you, which can help you solve any problems
Address：No. 3888, Hutai Road, Baoshan District, Shanghai, China
Low lateral impact: ,Helmet, impact at 8.5m/s. Peak deceleration ,shall not exceed, 275G. Advanced Ballistic Protection: A 225g metal projectile fired at 250km/h. The peak deceleration ,shall not exceed, 275G. Crush: A 10kg weight falling 5.1 metres onto the ,helmet,. Lateral and longitudinal tests. The ,transmitted force, should ,not exceed, 10 kN. Shell ...
No flame can be visible for five seconds after removing the test flame from the ,helmet, surface. 2. ,Force, transmission. A single ,helmet, must ,not, transmit ,force, to the test ,head form, exceeding 1,000 pounds of ,force,. Conditioned ,helmets, (hot and cold) ,shall, be averaged, and the average cannot ,exceed, 850 pounds of ,force, to the test ,head form,. 3.
Safety helmet, should withstand the impact of a plumb ball of 500gm weight with conical steel point having an included angle of 36 degree or a spherical point of radius ,not, more than 0.5mm, dropped from a height of 3 meter with pointed end downward onto the top of the crown of the ,helmet, without getting pierced, dented or suffering failure of any integral part.
The DOI/USFS Aviation ,Helmets, Standard Specification will provide an avenue to allow non-military approved ,helmets, to be considered for acquisition within our aviation communities. Both manufacturers and distributors can test their ,helmets, using an ISO certified laboratory to the DOI/USFS Aviation ,Helmet, …
A ,helmet shall not, have any rigid projections inside its shell. Rigid projections outside any ,helmet,’s shell ,shall, be limited to those required for operation of essential ac-cessories, and ,shall not, protrude more than 0.20 inch (5 mm). S5.6 Labeling. S5.6.1 Each ,helmet shall, …
126.96.36.199. The headforms used for the impact-absorption test ,shall, be made of metal and, together with any means for their support, ,shall, exhibit no resonance below a frequency of 2,000 Hz. Full headforms ,shall, have the following characteristics: (a) the centre of gravity ,shall, be located within a 10 mm radius of point G on the central vertical axis;
mounted upon a wooden ,headform,. One ,helmet, sample is used for each test. These tests are: Vertical energy absorption: A 5kg striker with a 50mm radius hemispherical end is dropped 2m onto the top of the ,helmet,, and the peak ,force transmitted, to the ‘neck’ measured. The CEN standard requires that ,the force, must ,not exceed, 10kN.